Kernel

Drone setup in minutes
not hours

Kernel is an AI agent that discovers, tests and monitors your drone’s hardware. It explains every fault in plain English and walks the operator through the fix in the field, with no specialist and no connectivity.

Runs on
FC-1 on-board · any PX4 autopilot via companion
Checks
47 pre-flight · continuous in-flight
Network
None required
Request demo works with any PX4 flight controller
Scanning
Kernel IMU0.02°/s drift GNSS14 sats · 0.8 HDOP Battery6S · 24.1 V ESC 3+18% current
Kernel agent On-device
Why won't it arm?
Reading ESC telemetry · 3.2 s hover
Motor 1Motor 3

  1. Swap the motor 3 prop — about a minute
  2. Re-seat the three motor 3 connectors
  3. Re-run pre-flight; I'll compare the traces
Done. Run it again.
All 47 checks pass. Motor 3 is within 2% of its pair — clear to arm.
Hardware · In production

Kernel, built
into the hardware.

We're engineering our own flight controller and ESC with Kernel on the board, so the agent sees every reading from the IMU to the motor phase, end to end.

Flight controller

Kernel FC

The agent lives on the board. It checks every sensor before takeoff and keeps watching through the flight.

ESC

Kernel ESC

Every motor reports its current, heat and speed to Kernel, so a failing motor is caught before it fails.

  • Made in USA
  • NDAA compliant
  • Blue UAS Framework
Pre Order First production run
Kernel link cmd → · ← telemetry H7 24M KERNEL IMU ×2 128M NDAA FC-1REV C M1M2 M4M3 ESC +− TVS ESC-4 Agent coreOn-board inference · offline Dual IMU0.02°/s drift BlackboxFull-rate log · 128 MB Phase current12.4 · 12.1 · 12.6 · 12.3 A FET temp31 °C eRPM18 240